Workflow

struct tcc_module tcc_instance;

1. 2.1.
   Create a TCC module configuration struct, which can be filled out to adjust the configuration of a physical TCC peripheral.

   struct tcc_config config_tcc;
   

2. 2.2.
   Initialize the TCC configuration struct with the module's default values.

   tcc_get_config_defaults(&config_tcc, CONF_PWM_MODULE);
   

   Note: This should always be performed before using the configuration struct to ensure that all values are initialized to known default settings.
3. 2.3.
   Alter the TCC settings to configure the counter width, wave generation mode and the compare channel 0 value.

   config_tcc.counter.clock_prescaler = TCC_CLOCK_PRESCALER_DIV1024;
   config_tcc.counter.period = 8000;
   config_tcc.compare.wave_generation = TCC_WAVE_GENERATION_SINGLE_SLOPE_PWM;
   config_tcc.compare.match[CONF_PWM_CHANNEL] = (8000 / 4);
   

4. 2.4.
   Alter the TCC settings to configure the PWM output on a physical device pin.

   config_tcc.pins.enable_wave_out_pin[CONF_PWM_OUTPUT] = true;
   config_tcc.pins.wave_out_pin[CONF_PWM_OUTPUT]        = CONF_PWM_OUT_PIN;
   config_tcc.pins.wave_out_pin_mux[CONF_PWM_OUTPUT]    = CONF_PWM_OUT_MUX;
   

5. 2.5.
   Configure the TCC module with the desired settings.

   tcc_init(&tcc_instance, CONF_PWM_MODULE, &config_tcc);
   

6. 2.6.
   Set to compare buffer value and enable circular of double buffered compare values.

   tcc_set_compare_value(&tcc_instance,
           (enum tcc_match_capture_channel)CONF_PWM_CHANNEL, 8000*3/4);
   tcc_enable_circular_buffer_compare(&tcc_instance,
           (enum tcc_match_capture_channel)CONF_PWM_CHANNEL);
   

7. 2.7.
   Enable the TCC module to start the timer and begin PWM signal generation.

   tcc_enable(&tcc_instance);