ZCDCON

Zero-Cross Detect Control Register
Name:
ZCDCON
Address:
0x04C
Reset:
Access:
Bit76543210
SENOUTPOLINTPINTN
AccessR/WRR/WR/WR/W
Reset0x000

Bit 7 – SEN: Zero-Cross Detect Software Enable

Zero-Cross Detect Software Enable

This bit is ignored when ZCD fuse is cleared.

ValueNameDescription
X ZCD Config fuse = 0

Zero-cross detect is always enabled. This bit is ignored.
1 ZCD Config fuse = 1

Zero-cross detect is enabled. ZCD pin is forced to output to source and sink current.
0 ZCD Config fuse = 1

Zero-cross detect is disabled. ZCD pin operates according to PPS and TRIS controls.

Bit 5 – OUT: Zero-Cross Detect Data Output

Zero-Cross Detect Data Output

ValueNameDescription
1 POL = 0 ZCD pin is sinking current
0 POL = 0 ZCD pin is sourcing current
1 POL = 1 ZCD pin is sourcing current
0 POL = 1 ZCD pin is sinking current

Bit 4 – POL: Zero-Cross Detect Polarity

Zero-Cross Detect Polarity

ValueDescription
1 ZCD logic output is inverted
0 ZCD logic output is not inverted

Bit 1 – INTP: Zero-Cross Detect Positive-Going Edge Interrupt Enable

Zero-Cross Detect Positive-Going Edge Interrupt Enable

ValueDescription
1 ZCDIF bit is set on low-to-high ZCD_output transition
0 ZCDIF bit is unaffected by low-to-high ZCD_output transition

Bit 0 – INTN: Zero-Cross Detect Negative-Going Edge Interrupt Enable

Zero-Cross Detect Negative-Going Edge Interrupt Enable

ValueDescription
1 ZCDIF bit is set on high-to-low ZCD_output transition
0 ZCDIF bit is unaffected by high-to-low ZCD_output transition