Power-Down Current (IPD)(1,2)

Table 1.
Standard Operating Conditions (unless otherwise stated)
Param. No.	Sym.	Device Characteristics	Min.	Typ.†	Max. +85°C	Max. +125°C	Units	Conditions
Param. No.	Sym.	Device Characteristics	Min.	Typ.†	Max. +85°C	Max. +125°C	Units	V_DD	VREGPM	Note
D200	I_PD	I_PD Base	—	1.1	3.3	4.6	μA	3.0V	`'b11`
			—	0.9	12.1	33.3	μA	3.0V	`'b10`
			—	29.5	45.5	68.9	μA	3.0V	`'b01`
			—	152	190	198.5	μA	3.0V	`'b00`
D201	I_{PD_WDT}	Low-Frequency Internal Oscillator/WDT	—	1.5	3.8	5.1	μA	3.0V	`'b11`
D202	I_{PD_SOSC}	Secondary Oscillator (S_OSC)	—	2.1	4.6	7.9	μA	3.0V	`'b11`
D203	I_{PD_LPBOR}	Low-Power Brown-out Reset (LPBOR)	—	1.3	3.5	4.8	μA	3.0V	`'b11`
D204	I_{PD_FVR_BUF1}	FVR Buffer 1 (ADC)	—	144.7	209.7	215.4	μA	3.0V	`'b11`
D204A	I_{PD_FVR_BUF2}	FVR Buffer 2 (DAC/CMP)	—	49.4	74.2	90.7	μA	3.0V	`'bx1` or `'b10`
D205	I_{PD_BOR}	Brown-out Reset (BOR)	—	16.6	20.4	20.8	μA	3.0V	`'b11`
D206	I_{PD_HLVD}	High/Low Voltage Detect (HLVD)	—	16.9	20.8	22.5	μA	3.0V	`'b11`
D207	I_{PD_ADCA}	ADC - Active	—	483	789	790	μA	3.0V	`'bx1` or `'b10`	ADC is converting (Note 4)
D208	I_{PD_CMP}	Comparator	—	52.5	84.2	105	μA	3.0V	`'b11`
* These parameters are characterized but not tested. † Data in “Typ.” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are not tested. Note: 1.The peripheral current is the sum of the base I_DD and the additional current consumed when this peripheral is enabled. The peripheral ∆ current can be determined by subtracting the base I_DD or I_PDcurrent from this limit. Max. values should be used when calculating total current consumption. 2.The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the part in Sleep mode with all I/O pins in high-impedance state and tied to V_SS. 3.All peripheral currents listed are on a per-peripheral basis if more than one instance of a peripheral is available. 4.ADC clock source is ADCRC.