CCPxCON

CCPxCON

CCP Control Register

Note:

1.The set and clear operations of the Compare mode are reset by setting MODE = 'b0000 or EN = 0.
2.When MODE = 'b0001 or 'b1011, then the timer associated with the CCP module is cleared. TMR1 is the default selection for the CCP module, so it is used for indication purpose only.

Name:: CCPxCON
Address:: 0x342,0x346,0x34A
Reset:
Access:

Bit7	6	5	4	3	2	1	0
EN		OUT	FMT	MODE[3:0]
AccessR/W		R	R/W	R/W	R/W	R/W	R/W
Reset0		x	0	0	0	0	0

Bit 7 – EN: CCP Module Enable

CCP Module Enable

Value	Description
1	CCP is enabled
0	CCP is disabled

Bit 5 – OUT: CCP Output Data (read-only)

CCP Output Data (read-only)

Bit 4 – FMT: CCPW (pulse-width) Value Alignment

CCPW (pulse-width) Value Alignment

Value	Name	Description
x	Capture mode	Not used
x	Compare mode	Not used
1	PWM mode	Left-aligned format
0	PWM mode	Right-aligned format

Bits 3:0 – MODE[3:0]: CCP Mode Select

CCP Mode Select

Table 1. CCPx Mode Select
MODE Value	Operating Mode	Operation	Set CCPxIF
`11xx`	PWM	PWM operation	Yes
`1011`	Compare	Pulse output; clear TMR1⁽²⁾	Yes
`1010`		Pulse output	Yes
`1001`		Clear output⁽¹⁾	Yes
`1000`		Set output⁽¹⁾	Yes
`0111`	Capture	Every 16^th rising edge of CCPx input	Yes
`0110`		Every 4^th rising edge of CCPx input	Yes
`0101`		Every rising edge of CCPx input	Yes
`0100`		Every falling edge of CCPx input	Yes
`0011`		Every edge of CCPx input	Yes
`0010`	Compare	Toggle output	Yes
`0001`	Compare	Toggle output; clear TMR1⁽²⁾	Yes
`0000`	Disabled		—