TXBC

This register is write-restricted and only writable if bit fields CCCR.CCE = 1 and CCCR.INIT = 1.

Note: Be aware that the sum of TFQS and NDTB may not be greater than 32. There is no check for erroneous configurations. The Tx Buffers section in the Message RAM starts with the dedicated Tx Buffers.

Bit31	30	29	28	27	26	25	24
	TFQM	TFQS[5:0]
Access	R/W	R/W	R/W	R/W	R/W	R/W	R/W
Reset	0	0	0	0	0	0	0
Bit23	22	21	20	19	18	17	16
		NDTB[5:0]
Access		R/W	R/W	R/W	R/W	R/W	R/W
Reset		0	0	0	0	0	0
Bit15	14	13	12	11	10	9	8
TBSA[15:8]
AccessR/W	R/W	R/W	R/W	R/W	R/W	R/W	R/W
Reset0	0	0	0	0	0	0	0
Bit7	6	5	4	3	2	1	0
TBSA[7:0]
AccessR/W	R/W	R/W	R/W	R/W	R/W	R/W	R/W
Reset0	0	0	0	0	0	0	0

Bit 30 – TFQM: Tx FIFO/Queue Mode

Tx FIFO/Queue Mode

Value	Description
0	Tx FIFO operation.
1	Tx Queue operation.

Bits 29:24 – TFQS[5:0]: Transmit FIFO/Queue Size

Transmit FIFO/Queue Size

Value	Description
0	No Tx FIFO/Queue.
1 - 32	Number of Tx Buffers used for Tx FIFO/Queue.
>32	Values greater than 32 are interpreted as 32.

Bits 21:16 – NDTB[5:0]: Number of Dedicated Transmit Buffers

Number of Dedicated Transmit Buffers

Value	Description
0	No Tx FIFO/Queue.
1 - 32	Number of Tx Buffers used for Tx FIFO/Queue.
>32	Values greater than 32 are interpreted as 32.

Bits 15:0 – TBSA[15:0]: Tx Buffers Start Address

Tx Buffers Start Address

Start address of Tx Buffers section in Message RAM. When the CAN module addresses the Message RAM it addresses 32-bit words, not single bytes. The configurable start addresses are 32-bit word addresses, i.e. only bits 15 to 2 are evaluated, the two least significant bits are ignored. Bits 1 to 0 will always be read back as “00”.