| Bit31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 |
| Access | |||||||
| Reset | |||||||
| Bit23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
| RXEN | |||||||
| Access | R/W | ||||||
| Reset | 0 | ||||||
| Bit15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 |
| AMODE[1:0] | MSSEN | SSDE | |||||
| AccessR/W | R/W | R/W | R/W | ||||
| Reset0 | 0 | 0 | 0 | ||||
| Bit7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
| PLOADEN | CHSIZE[2:0] | ||||||
| Access | R/W | R/W | R/W | R/W | |||
| Reset | 0 | 0 | 0 | 0 | |||
Receiver Enable
Writing '0' to this bit will disable the SPI receiver immediately. The receive buffer will be flushed, data from ongoing receptions will be lost and STATUS.BUFOVF will be cleared.
Writing '1' to CTRLB.RXEN when the SPI is disabled will set CTRLB.RXEN immediately. When the SPI is enabled, CTRLB.RXEN will be cleared, SYNCBUSY.CTRLB will be set and remain set until the receiver is enabled. When the receiver is enabled CTRLB.RXEN will read back as '1'.
Writing '1' to CTRLB.RXEN when the SPI is enabled will set SYNCBUSY.CTRLB, which will remain set until the receiver is enabled, and CTRLB.RXEN will read back as '1'.
This bit is not enable-protected.
| Value | Description |
|---|---|
| 0 | The receiver is disabled or being enabled. |
| 1 | The receiver is enabled or it will be enabled when SPI is enabled. |
Address Mode
These bits set the slave addressing mode when the frame format (CTRLA.FORM) with address is used. They are unused in master mode.
| AMODE[1:0] | Name | Description |
|---|---|---|
| 0x0 | MASK | ADDRMASK is used as a mask to the ADDR register |
| 0x1 | 2_ADDRS | The slave responds to the two unique addresses in ADDR and ADDRMASK |
| 0x2 | RANGE | The slave responds to the range of addresses between and including ADDR and ADDRMASK. ADDR is the upper limit |
| 0x3 | - | Reserved |
Master Slave Select Enable
This bit enables hardware slave select (SS) control.
| Value | Description |
|---|---|
| 0 | Hardware SS control is disabled. |
| 1 | Hardware SS control is enabled. |
Slave Select Low Detect Enable
This bit enables wake up when the slave select (SS) pin transitions from high to low.
| Value | Description |
|---|---|
| 0 | SS low detector is disabled. |
| 1 | SS low detector is enabled. |
Slave Data Preload Enable
Setting this bit will enable preloading of the slave shift register when there is no transfer in progress. If the SS line is high when DATA is written, it will be transferred immediately to the shift register.
Character Size
| CHSIZE[2:0] | Name | Description |
|---|---|---|
| 0x0 | 8BIT | 8 bits |
| 0x1 | 9BIT | 9 bits |
| 0x2-0x7 | - | Reserved |