Hardware Setup for On-board Programming

  1. 1.Mount the routing and socket card, and the target device. See the Socket System section on how to do this.
  2. 2.Use a 10-wire cable supplied with the STK600 to connect the PROG DATA to the target device, as shown in the picture below.
  3. 3.Note that for ATtiny24/44/84 a cable on PROG CTRL is required as well, as for the Parallel High-Voltage Programming.
  4. 4.Mount both the VTARGET jumper and the RESET jumper.
  5. 5.Ensure that VTARGET is between 4.5 and 5.5V before programming.

See the Programming Dialog pages in the Atmel Studio help file for information on the STK600 programming dialog.



Parent topic: Serial High-Voltage Programming